石油学报 ›› 2014, Vol. 35 ›› Issue (5): 908-913.DOI: 10.7623/syxb201405010

• 油田开发 • 上一篇    下一篇

聚驱后缔合聚合物三元复合驱提高采收率技术

杨菲1,2, 郭拥军1, 张新民1, 罗平亚1   

  1. 1. 西南石油大学油气藏地质及开发工程国家重点实验室 四川成都 610500;
    2. 大庆油田有限责任公司技术发展部 黑龙江大庆 163453
  • 收稿日期:2014-04-30 修回日期:2014-06-14 出版日期:2014-09-25 发布日期:2014-08-05
  • 通讯作者: 罗平亚,男,1940年6月生,1962年获四川石油学院学士学位,现为中国工程院院士、西南石油大学教授、博士生导师,主要从事油田化学工程与技术研究与教学工作。Email:luopy@swpu.edu.cn
  • 作者简介:杨菲,女,1967年5月生,1989年获天津大学学士学位,2004年获哈尔滨工业大学硕士学位,现为大庆油田有限责任公司技术发展部副主任、高级工程师,主要从事提高采收率技术研究以及勘探开发科研管理工作。Email:yangfei@petrochina.com.cn
  • 基金资助:

    国家重大科技专项(2011ZX05011-004)资助。

Enhanced oil recovery technology of alkaline/surfactant/hydrophobically associating polyacrylamide flooding after polymer flooding

Yang Fei1,2, Guo Yongjun1, Zhang Xinmin1, Luo Pingya1   

  1. 1. State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University, Sichuan Chengdu 610500, China;
    2. Department of Science and Technology Development, Daqing Oilfield Company Limited, Heilongjiang Daqing 163453, China
  • Received:2014-04-30 Revised:2014-06-14 Online:2014-09-25 Published:2014-08-05

摘要:

三元复合驱是大庆油田聚驱后进一步提高采收率的重要途径,其驱油体系须保证超低油-水界面张力,且能大幅提高波及能力。通过研究烷基苯磺酸盐(ABS)-缔合聚合物(HAPAM)-NaOH三元复合驱体系的性能,并与超高分子量部分水解聚丙烯酰胺(HPAM)三元复合体系进行对比。研究结果表明,HAPAM三元复合体系在NaOH浓度为0.5%~1.2%、ABS浓度为0.025%~0.300%时具有良好的界面活性,油-水界面张力可达10-3mN/m数量级。0.16%HAPAM-0.3%ABS-1.2%NaOH三元复合体系黏度达108.8 mPa ·s,采用HPAM达到相同黏度其浓度为0.265%,因此HAPAM可降低聚合物用量40%。驱油实验结果表明,在相同黏度下,HAPAM三元复合体系在不同孔隙介质中均能提高聚驱后采收率13%以上,比HPAM三元复合体系多提高采收率6%以上。HAPAM三元复合体系具有更高的阻力系数与残余阻力系数、更好的黏弹性以及乳化稳定性,可以为大庆油田聚驱后提高采收率提供新的技术手段。

关键词: 缔合聚合物, 三元复合驱, 聚合物驱后, 提高采收率, 界面张力, 黏度

Abstract:

Alkaline/surfactant/hydrophobically associating polyacrylamide (ASP) flooding is an important approach for further improving oil recovery after polymer flooding in Daqing oilfield. For cost-effective improvement of oil recovery efficiency, ASP flooding systems must be able to maintain ultra-low oil-water interfacial tension and substantially increase the sweep efficiency. This study evaluates the performance of an alkylbenzene sulfonate (ABS)-hydrophobically associating polyacrylamide (HAPAM)-sodium hydroxide (NaOH) flooding system by comparison with an ultra-high molecular weight, partially hydrolyzed polyacrylamide (HPAM)-ABS-NaOH flooding system. The results show that when the ranges of NaOH and ABS concentrations are respectively 0.5 % -.2 % and 0.025 % -0.300 % , the HAPAM-APS flooding system has high interfacial activity with oil-water interfacial tension decreased to 10-3 mN/m. The HAPAM-APS solution containing 0.16 % HAPAM, 0.3 % ABS, and 1.2 % NaOH has the viscosity of 108.8 mPa ·s, while the HPAM-APS solution of the same viscosity contains 0.265 % HPAM. That is, compared with HPAM, HAPAM reduces the consumption of polymer in APS flooding systems by approximately 40 % . The oil displacement experiment shows that the HAPAM-ABS-NaOH solution improves oil recovery after polymer flooding by more than 13 % in different porous media at the same viscosity. That is, 6 % more than that by the HPAM-ABS-NaOH solution. Additionally, the HAPAM-ABS-NaOH flooding system has greater resistance factor and residual resistance factor, higher viscoelasticity, and better emulsion stability than the HPAM-ABS-NaOH flooding system. This study indicates that HAPAM-APS flooding provides a new technical approach for enhanced oil recovery in Daqing oilfield after polymer flooding.

Key words: hydrophobically associating polyacrylamide, alkaline-surfactant-polymer flooding, after polymer flooding, enhanced oil recovery, interfacial tension, viscosity

中图分类号: