石油学报 ›› 2020, Vol. 41 ›› Issue (7): 865-874.DOI: 10.7623/syxb202007008

• 油田开发 • 上一篇    下一篇

新型排水采气用抗凝析油泡排剂

瞿超超1, 刘正中2, 殷鸿尧1, 鲁光亮3, 李祖友3, 冯玉军1   

  1. 1. 四川大学高分子研究所 四川成都 610065;
    2. 中国石油化工股份有限公司西南油气分公司 四川成都 610016;
    3. 中国石油化工股份有限公司西南油气分公司川西采气一厂 四川德阳 618000
  • 收稿日期:2019-03-29 修回日期:2019-12-20 出版日期:2020-07-25 发布日期:2020-08-08
  • 通讯作者: 冯玉军,男,1971年3月生,1994年获西南石油学院学士学位,1999年获西南石油学院博士学位,现为四川大学研究员、博士生导师,主要从事软物质材料及油田化学的研究。Email:yjfeng@scu.edu.cn
  • 作者简介:瞿超超,男,1994年11月生,2016年获湖北大学学士学位,2019年获四川大学硕士学位,现为东风本田汽车有限公司涂装工程师,主要从事汽车涂装技术及汽车涂装材料方面的研究。Email:chaochaoqu123@foxmail.com.cn
  • 基金资助:

    国家科技重大专项"低压低产井高效泡排剂的研发与应用研究"(2016ZX05048-004-007)和国家自然科学基金面上项目(No.21773163)资助。

A new anti-condensate foaming agent for drainage gas recovery

Qu Chaochao1, Liu Zhengzhong2, Yin Hongyao1, Lu Guangliang3, Li Zuyou3, Feng Yujun1   

  1. 1. Polymer Research Institute, Sichuan University, Sichuan Chengdu 610065, China;
    2. Sinopec Southwest Oil and Gas Company, Sichuan Chengdu 610016, China;
    3. No.1 Gas Production Plant, Sinopec Southwest Oil and Gas Company, Sichuan Deyang 618000, China
  • Received:2019-03-29 Revised:2019-12-20 Online:2020-07-25 Published:2020-08-08

摘要:

泡沫排水采气是提高低压低产井天然气产量的重要手段之一,但对于含凝析油气井,由于普通泡沫具有遇油消泡的特点,导致常规泡排剂难以产生足量泡沫,从而使排液效果变差。利用阴离子表面活性剂SDS、两性离子表面活性剂CHSB、氟碳表面活性剂PFBS三者的协同作用研制了耐油泡排剂COT。采用罗氏泡沫仪、高温高压可视化泡沫仪、激光共聚焦显微镜研究了凝析油含量、温度、压力和矿化度对泡沫性能的影响,揭示了耐油机理,并与常规泡排剂XA进行了对比研究。研究结果表明,在常压、80℃下,随着凝析油含量的升高,COT泡沫的最大起泡高度(Hmax)和半衰期(t1/2)逐渐升高,而XA的泡沫性能却逐渐减弱;在高压下,随着温度升高,COT泡沫的Hmax不受影响,但t1/2却逐步下降。当固定温度时,随着压力升高,COT泡沫的Hmaxt1/2均显著提升,且在相同的压力和温度下,COT的泡沫综合性能优于XA;随着矿化度升高,COT泡沫的Hmax略微下降,t1/2却显著上升。通过研究油滴与泡沫液膜之间的相互作用发现,当油滴接触到COT泡沫液膜时,会形成稳定的假乳液膜,阻止油滴继续渗入,从而形成稳定的耐油泡沫。新型泡排剂已在12口气井得到了现场应用,累积增产天然气26.35×104m3

关键词: 排水采气, 耐油泡沫, 表面活性剂复配, 假乳液膜, 动态泡沫

Abstract:

Foam drainage gas recovery is one of the important means to increase the gas production of low-pressure and low-production wells. However, defoaming occurs when foams encounter oil in condensate-bearing gas wells, so it is difficult for conventional foaming agent to generate sufficient foams, which makes the drainage effect worse. The oil-resistant foaming agent COT was developed using the synergistic effect of the anionic surfactant SDS, the zwitterionic surfactant CHSB, and the fluorocarbon surfactant PFBS. Using a ROSS-Miles foam meter, a high-temperature and high-pressure visual foam meter, and a laser scanning confocal microscope, the effect of condensate content, temperature, pressure, and salinity on foam performance was studied, and the mechanism of oil resistance was revealed. Furhter, a comparative study is performed between COT and the conventional foaming agent XA. The results show that at normal pressure and 80℃, the maximum foaming height (Hmax)and half-life time (t1/2)of COT foam gradually increased with the increasing condensate content, while the foam performance of XA gradually weakened. Under high pressure, as the temperature increased, the Hmax of COT foam was not changed, but t1/2 gradually decreased. When the temperature was fixed, with the increasing of pressure, the Hmax and t1/2 of COT foam increased significantly, and the comprehensive performance of COT foam was superior to XA under the same pressure and temperature. With the increasing of salinity, the Hmax of COT foam decreased slightly, but t1/2 increased significantly. By studying the interaction between the oil droplets and the foam film, it is found that when the oil droplets contact with the COT foam film, a stable pseudoemulsion film is formed preventing the oil droplets from continuing to penetrate, thereby forming stable and oil-resistant foams. The foaming agent developed based on the above-mentioned laboratory research has been applied in 12 gas wells in the field, with the cumulative gas production increased by 26.35×104m3.

Key words: drainage gas recovery, oil resistant foam, complex formulation of surfactants, pseudoemulsion film, dynamic foam

中图分类号: